TM 9-2320-366-34-2
(5) Position six washers (6) and screws (7) on bottom half
of intermediate differential carrier (3).
(6) Tighten six screws (5 and 7) to 74-98 lb-ft (100-133
N·m).
CAUTION
Ensure needle bearings are aligned prior to
installation of yoke bearing cups on universal
joint end caps. Failure to comply may result
in damage to equipment.
(7) Remove drive shaft (8) from frame (9).
(8) Position universal joint (10) on drive yoke (11) with two
bearing cups (12) and four screws (13).
(9) Tighten four screws (13) to 26-35 lb-ft (35-47 N·m).
(10) Install air hose (14) on fitting (15).
Change 1
10-35