TM 9-2320-366-34-2
10-6. INTERMEDIATE AXLE DIFFERENTIAL CARRIER REPLACEMENT (CONT)
(4) Remove four screws (7) and two bearing cups (8) from
drive yoke (9).
(5) Slide drive shaft (10) from side to side and separate
universal joint (11) from drive yoke (9).
(6) Attach drive shaft (10) to frame (6).
(7) Remove air hose (12) from fitting (13).
(8) Remove six screws (14) and washers (15) from bottom
half of intermediate differential carrier (16).
(9) Position transmission/differential lift under intermediate
differential carrier (16).
WARNING
Intermediate differential carrier weighs
approximately 350 lbs (159 kgs). Attach a
suitable lifting device prior to removal.
Failure to comply may result in injury to
personnel or damage to equipment.
(10) Remove six screws (17) and washers (18) from top half
of intermediate differential carrier (16).
(11) Remove intermediate differential carrier (16) from axle
assembly (19).
10-34
Change 1