TM 9-2320-366-34-4
Section II. MAINTENANCE PROCEDURES
22-2. TRANSFER CASE MODULE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Transmission mounted on maintenance stand
(para 7-5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Stand, Maintenance, Automotive Engine (TM 9-
2320-366-20)
Bracket Assembly, Lift, Transfer Case (Item 24,
Appendix D)
Tools and Special Tools (Cont)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Materials/Parts
Screw, Hex Head (8) (Item 79, Appendix C)
Packing, Preformed (Item 296, Appendix F)
Gasket (Item 70, Appendix F)
Personnel Required
(2)
a. Removal.
(1) Disconnect hose (1) from 45-degree fitting (2).
(2) Remove 45-degree fitting (2) and screen (3) from
transfer case module (4).
(3) Remove preformed packing (5) from 45-degree fitting (2).
Discard preformed packing.
(4) Position transfer case lift bracket on transfer case
module (4) with eight screws (6).
(5) Tighten eight screws (6) to 42-50 lb-ft (57-68 N·m).
22-2
Change 1
