TM 9-2320-366-34-4
21-4. ROTATING CLUTCH MODULE REPAIR (CONT)
(28) Inspect thrust bearing (17) for scoring and damage.
(29) Inspect clutch assembly (18) for scuffing, nicks, and
burrs.
(30) Measure spline wear on clutch assembly (18), maximum
distance between splines 0.015 in. (0.038 cm).
(31) Measure bushing (19), maximum inside diameter of
bushing is 3.901 in. (9.908 cm).
(32) Inspect shaft (20) for cracks, nicks, and scuffing.
(33) Measure inside diameter of bushing (21), maximum
diameter 0.795 in. (2.019 cm).
c. Assembly.
NOTE
Apply lubricating oil to all parts during
assembly.
(1) Install bushing (1) in gear (2).
(2) Install two seals (3) on gear (2).
(3) Install sealring (4) on C2 piston (5).
(4) Install sealring (6) on C1 piston (7).
(5) Install C1 piston (7) in C2 piston (5).
(6) Install C2 piston (5) on gear (2).
(7) Install thrust bearing (8) in gear (2).
21-26
