TM 9-2320-366-34-3
d. Assembly.
NOTE
Apply lubricating oil to parts during assembly.
(1) Install two bushings (1) in cable guide sheaves (2).
(2) Install two cable guide sheaves (2) and roller shafts (3)
on base mounts (4) with spring pins (5).
WARNING
Use care when installing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure to
comply may result in injury to personnel.
(3) Install secondary sun gear (6) in primary carrier
assembly (7) with two retaining rings (8).
(4) Install ball bearing (9) and shaft seal (10) in gear end
flange (11).
(5) Install preformed packing (12) on gear end flange (11).
(6) Position gear end flange (11) on ring gear (13) with 20
lockwashers (14) and screws (15).
(7) Tighten 20 screws (15) to 38-45 lb-ft (52-61 N·m).
16-550
16-88. 15K SELF-RECOVERY WINCH (SRW) ASSEMBLY REPLACEMENT/REPAIR (CONT)
