TM 9-2320-366-34-3
NOTE
Replace any part that fails visual inspection
or size measurement requirements.
(2) Inspect retaining pin (1) for pitting, burrs, indications of
binding or damaged threads.
(3) Inspect retaining pin (1) for minimum outside diameter
2.49 in. (6.32 cm).
(4) Inspect two bushings (2) for pits, corrosion or burrs.
(5) Inspect spacer (3) for pits, corrosion, or burrs.
(6) Inspect two pivot yoke bushings (4) for pits, corrosion or
burrs.
(7) Inspect pivot pin (5) for pitting, burrs, indications of
binding or damaged threads.
(8) Inspect thrust bearing (6) for cracks or excessive
grooving. Minimum thickness 0.062 in. (0.16 cm).
d. Assembly.
(1) Install two pivot yoke bushings (1) in pivot yoke (2).
(2) Position bushing (3) and pivot pin (4) in pivot yoke (2)
with four screws (5).
(3) Tighten four screws (5) to 30-33 lb-ft (41-45 N·m)
16-421