TM 9-2320-366-34-3
b. Disassembly.
NOTE
Left and right side of crossbar are
disassembled the same way.
Left side
shown.
(1) Remove three screws (1) and washers (2) from
adjustment block (3).
(2) Remove three screws (4) from adjustment block (3).
(3) Remove two spring pins (5) and nuts (6) from adjusting
screw (7). Discard spring pins.
(4) Remove adjustment block (3) and shim pack (8) from
crossbar (9).
(5) Remove mounting block (10) and adjustment screw (7)
from crossbar (9).
(6) Remove adjustment screw (7) from mounting block (10).
(7) Remove latch pin (11) and pin (12) from mounting block
(10).
(8) Remove pin (13) from crossbar (9).
(9) Remove lockwire (14), three screws (15), washers (16),
plate (17), shim pack (18), thrust washer (19), and pivot
yoke (20) from crossbar (9). Discard shim pack and
lockwire.
16-419
