TM 9-2320-366-34-3
16-70. M1089 STINGER CYLINDER REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Crossbar assembly removed (para 16-69).
Stinger extended with outer end slightly higher
than inner end (TM 9-2320-366-10-2).
Engine shut down (TM 9-2320-366-10-1).
Hydraulic reservoir supply and return valve
closed (TM 9-2320-366-10-2).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Pan, Drain (Item 43, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix
B)
Tools and Special Tools (Cont)
Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-20)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive Tape (Item 30,
Appendix C)
Solvent, Dry Cleaning (Item 83, Appendix C)
Preformed Packing (2) (Item 234, Appendix F)
Personnel Required
(2)
a. Removal.
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
(1) Remove two retaining rings (1) from retaining pin (2).
(2) Remove retaining pin (2) from inner tube (3).
16-425
