TM 9-2320-366-34-3
(12) Remove three self-locking nuts (32) and screws (33)
from mounting plate (34). Discard self-locking nuts.
(13) Remove two self-locking nuts (35), screws (36),
mounting plate (34), and monoblock valve (37) from 30K
winch assembly (10). Discard self-locking nuts.
NOTE
Left and right side maker lights are removed the
same way. Left side shown.
Refer to Table 16-1. Clearance Marker Light
Connectors for combinations of terminal lugs
and connections on each marker light.
(14) Remove nut (38), washer (39), and terminal lug (40)
from marker light (41).
(15) Disconnect electrical connector 489 (42) from harness
connector (43).
(16) Remove electrical harness (44) from 30K winch
assembly (10).
(17) Removed three self-locking nuts (45), screws (46), and
lamp bracket (47) from 30K winch assembly (10).
Discard self-locking nuts.
(18) Perform steps (14) through (17) on right side marker light.
Table 16-1. Clearance Marker Light Connectors
Marker Light Location
Connector
Terminal Lug
Left Side
P94
TL88
Right Side
P95
TL89
Change 1
16-349
