TM 9-2320-366-34-3
(28) Connect three pneumatic hoses (37) to 45-degree fittings
(38).
WARNING
Adhesive Sealant MIL-S-46163 can damage
your eyes. Wear safety goggles when using;
avoid contact with eyes. Failure to comply
may result in injury to personnel. If sealant
contacts eyes, flush eyes with water and get
immediate medical attention.
Failure to
comply may result in injury to personnel.
(29) Apply sealing compound to threads of two screws (39).
(30) Position two screws (39) in left side bearing housing
(25).
(31) Tighten two screws (39) to 34-42 lb-ft (47-57 N·m).
(32) Perform steps (29) through (31) on right side bearing
housing.
(33) Position steering column universal joint (40) on steering
gear (41) with matchmarks aligned.
(34) Position screw (42) and self-locking nut (43) in steering
column universal joint (40).
(35) Tighten self-locking nut (43) to 31-39 lb-ft (43-53 N·m).
NOTE
Install plastic cable ties as required.
(36) Route throttle control cable (44) to bracket (45).
(37) Position throttle control cable (44) in bracket (45) with
two nuts (46).
(38) Adjust and tighten nuts (46) to position marked during
removal.
(39) Install throttle control cable (44) on stud (47) with clip
(48).
15-81
