TM 9-2320-366-34-2
13-22. M1088 FRAME PLATE REPLACEMENT
This task covers:
a. LH Removal
b. LH Installation
c. RH Removal
d. RH Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Fifth wheel assembly removed (para 13-46).
Rear axle bogie shaft removed (para 10-4).
Rear torque rods removed (para 14-5).
Resilient mount and mechanical stops removed (TM 9-
2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Wrench, Impact, Electric (Item 88, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Wrench, Torque 0-150 lb-in. (Item 91, Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Materials/Parts
Nut, Self-Locking (3) (Item 173, Appendix F) (LH
side)
Nut, Self-Locking (2) (Item 173, Appendix F) (RH
side)
Lockwasher (Item 166, Appendix F)
Nut, Self-Locking (Item 202, Appendix F)
Nut, Self-Locking (8) (Item 212, Appendix F)
Bolt (13) (Item 2, Appendix F)
Nut, Self-Locking (13) (Item 204, Appendix F)
Nut, Self-Locking (2) (Item 210, Appendix F)
Nut, Self-Locking (4) (Item 211, Appendix F)
Adhesive (Item 10.1, Appendix C)
Grommet, Nonmetallic (Item 71.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. LH Removal.
(1) Remove two self-locking nuts (1), bolts (2), and clamps
(3) from frame plate (4). Discard self-locking nuts.
Change 1
13-171
