TM 9-2320-366-34-2
13-7. REAR CROSSMEMBER REPLACEMENT (CONT)
(8) Position support (8) on rear crossmember (1) with four
screws (9) and self-locking nuts (10).
(9) Tighten four self-locking nuts (10) to 195-239 lb-ft (265-
325 N·m).
(9.1) Apply coat of grease to shaft of pintle hook (11).
(10) Install pintle hook (11) in rear crossmember (1) with
washer (12) and nut (13).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.007-0.043 cm). Failure
to comply may result in damage to
equipment.
(11) Adjust nut (13) until clearance is 0.003-0.017 in. (0.007-
0.043 cm) with alignment holes lined up between nut
(13) and pintle hook (11).
(12) Install cotter pin (14) in nut (13).
i. M1085 Removal.
(1) Remove cotter pin (1) from nut (2). Discard cotter pin.
(2) Remove nut (2) and washer (3) from pintle hook (4).
(3) Remove pintle hook (4) from rear crossmember (5).
(4) Remove four self-locking nuts (6), screws (7), and
support (8) from rear crossmember (5). Discard self-
locking nuts.
13-46 Change 1
