TM 9-2320-366-34-2
13-7. REAR CROSSMEMBER REPLACEMENT (CONT)
(11) Position bolt (13) and self-locking nut (14) in front shock
absorber bracket (15).
(12) Position bolt (16) and self-locking nut (17) in rear shock
absorber bracket (18).
(13) Tighten self-locking nuts (14 and 17) to 210-225 lb-ft
(285-305 N·m).
(14) Perform steps (2) through (13) on right side of rear
crossmember.
(15) Position support (19) on rear crossmember (1) with four
screws (20) and self-locking nuts (21).
(16) Tighten four self-locking nuts (21) to 195-239 lb-ft (265-
325 N·m).
(16.1) Apply coat of grease to shaft of pintle hook (22).
(17) Install pintle hook (22) in rear crossmember (1) with
washer (23) and nut (24).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.007-0.043 cm). Failure
to comply may result in damage to
equipment.
(18) Adjust nut (24) until clearance is 0.003-0.017 in. (0.007-
0.043 cm) with alignment holes lined up between nut
(24) and pintle hook (22).
(19) Install cotter pin (25) in nut (24).
13-42
Change 1
