TM 9-2320-366-34-2
13-7. REAR CROSSMEMBER REPLACEMENT (CONT)
(3) Position two bolts (4) and self-locking nuts (5) in rear
crossmember (1).
(4) Tighten two self-locking nuts (5) to 210-225 lb-ft (285-
305 N·m).
(5) Perform steps (1) through (4) on right side of rear
crossmember.
(6) Position support (6) on rear crossmember (1) with four
screws (7) and self-locking nuts (8).
(7) Tighten four self-locking nuts (8) to 195-239 lb-ft (265-
325 N·m).
(8) Install pintle hook (9) in rear crossmember (1) with
washer (10) and nut (11).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.007-0.043 cm). Failure
to comply may result in damage to
equipment.
(9) Adjust nut (11) until clearance is 0.003-0.017 in. (0.007-
0.043 cm) with alignment holes lined up between nut and
pintle hook (9).
(10) Install cotter pin (12) in nut (11).
k.
Follow-on Maintenance
(1) Lubricate pintle hook (TM 9-2320-366-20).
(2) Install M1094 extraction tube (para 13-12).
(3) Install M1083/M1093 rear shock absorbers (TM 9-2320-
366-20-4).
13-48
