TM 9-2320-366-34-2
13-6. REAR TENSION BEAM AND TAILLIGHT MOUNTING BRACKET REPLACEMENT
(CONT)
e. M1084/M1086 Removal.
NOTE
• Left and right side of rear tension beam is
removed the same way. Left side shown.
• Steps (1) and (2) require the aid of an assistant.
(1) Remove pin (1) and shackle (2) from rear tension beam
(3).
CAUTION
When removing bolts, continuous removal of
collars is mandatory. Failure to comply will
result in seizing of collar to bolt.
(2) Remove six collars (4) and bolts (5) from rear tension
beam (3). Discard collars and bolts.
(3) Perform steps (1) and (2) on right side tension beam.
(4) Remove rear tension beam (3) from vehicle.
f. M1084/M1086 Installation.
NOTE
• Left and right side of rear tension beam is
installed the same way. Left side shown.
• Steps (1) and (2) require the aid of an assistant.
(1) Position rear tension beam (1) on vehicle with six bolts
(2) and self-locking nuts (3).
(2) Tighten six self-locking nuts (3) to 210-225 lb-ft (285-305
N·m).
(3) Install shackle (4) on rear tension beam (1) with pin (5).
(4) Perform steps (1) through (3) on right side of rear
tension beam.
13-24
