TM 9-2320-366-34-2
13-6. REAR TENSION BEAM AND TAILLIGHT MOUNTING BRACKET REPLACEMENT
(CONT)
j. M1090 Installation.
NOTE
• Left and right side of rear tension beam is
installed the same way. Left side shown.
• Steps (1) through (5) require the aid of an
assistant.
(1) Position rear tension beam (1) and taillight mounting
bracket (2) on vehicle with four bolts (3) and self-locking
nuts (4).
(2) Tighten self-locking nuts (4) to 210-225 lb-ft (285-305
N·m).
(3) Position two bolts (5) and self-locking nuts (6) in rear
tension beam (1).
(4) Tighten two self-locking nuts (6) to 210-225 lb-ft (285-
305 N·m).
(5) Install shackle (7) on rear tension beam (1) with pin (8).
(6) Perform steps (1) through (5) on right side of rear
tension beam.
13-28
