TM 9-2320-366-34-2
(15) Install seal (14) on access cover (15).
CAUTION
Washer bearing must be positioned with
grooves facing up and hole aligned with pin
in steering knuckle.
(16) Install washer bearing (16) on access cover (15).
(17) Position access cover (15) on steering knuckle (3) with
four washers (17) and screws (18).
(18) Tighten four screws (18) to 500-650 lb-ft (678-881 N·m).
(19) Install grease fitting (19) on access cover (15).
(20) Install dial indicator on front axle (2) so pointer contacts
surface of pivoting arm (4).
(21) Use floor jack and raise steering knuckle (3) to apply
pressure to access cover (15).
(22) Set dial indicator to zero.
NOTE
End play should read between 0.005-0.015
in. (0.0127-0.0381 cm).
(23) Lower floor jack from steering knuckle (3).
(24) Read end play on dial indicator.
9-27