TM 9-2320-366-34-2
9-6. STEERING KNUCKLE MECHANISM REPLACEMENT (CONT)
(7) Remove self-locking nut (14), screw (15), and clamp (16)
from bracket (17). Discard self-locking nut.
(8) Remove four screws (18), washers (19), washer bearing
(20), and access cover (21) from steering knuckle (4).
(9) Remove grease fitting (22) from access cover (21).
(10) Remove seal (23) from access cover (21). Discard seal.
(11) Support steering knuckle (4) with floor jack.
(12) Use floor jack to raise steering knuckle (4) and remove
pressure from pivoting arm (8).
(13) Remove screw (24), washer (25), bracket (17), and
washer (26) from pivoting arm (8).
(14) Remove three screws (27), washers (28), pivoting arm
(8), and shim(s) (29) from steering knuckle (4).
(15) Remove grease fitting (30) from pivoting arm (8).
(16) Remove seal (31) from pivoting arm (8). Discard seal.
(17) Remove floor jack from steering knuckle (4).
9-24