TM 9-2320-366-34-2
7-17. ENGINE AND TRANSMISSION MOUNT BRACKET REPLACEMENT
This task covers:
a. LH Removal
b. LH Installation
c. RH Removal
d. RH Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Hydraulic tank supply and return valves closed (TM 9-
2320-366-10-2) (M1089).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Pan, Drain (Item 24, Appendix C) (M1089)
Tools and Special Tools (Cont)
Jack, Dolly Type, Hydraulic (Item 37, Appendix
B)
4x4x8 in. (20 cm) wooden piece
Materials/Parts
Nut, Self-locking (2) (Item 173, Appendix F)
Sealant, Pipe (Item 68.1, Appendix C)
Personnel
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to
personnel.
a. LH Removal.
NOTE
Hydraulic jack is used to support engine
and transmission while LH engine and
transmission mount bracket is being
replaced.
(1) Position hydraulic jack with 8 in. (20 cm) wooden block
under transmission control valve module (1).
(2) Raise hydraulic jack to apply pressure to transmission
(2).
Change 1
7-101
