TM 9-2320-366-34-2
D-21. SPREADER BAR
Make the Spreader Bar for cab removal from steel channel stock and round rod stock according to the following steps.
Refer to the parts list table and figure for details.
Item
Part
Number
Material Description
Size
Qty
1
N/A
5 inch Channel, steel,
ASTM A-36
78.0 in. (198 cm) X 5.00 in. (12.7 cm) X 1.75
in. (4.4 cm) X 0.38 in. (0.96 cm) thick
1
2
N/A
Rod, steel, ASTM A-36
29.0 in. (73.6 cm) X 1.00 in. OD (2.54 cm)
1
3
N/A
Rod, steel, ASTM A-36
13.0 in. (33.0 cm) X 1.00 in. OD (2.54 cm)
2
Figure D-32. Spreader Bar Layout
a. All dimensions are in inches (centimeters).
b. Heat and bend lift rod (2) to dimensions shown in Figure D-32. Spreader Bar Layout.
c. Heat and bend two guide rods (3) to dimensions shown in Figure D-32. Spreader Bar Layout.
d. Cut lift rod (2) and guide rods (3) to final dimensions shown in Figure D-32
Spreader Bar Layout.
e. De-burr and remove sharp edges.
D-37
