TM 9-2320-366-34-2
D-15. MARKING SLEEVE FABRICATION
Fabricate marking sleeves according to the following information.
a. Cut from bulk sleeve material 12414663 FP-301-12.7, 2 inches (5.2 cm).
b. All dimensions are in inches (centimeters).
c. Identify by applying the following applicable numbers to the sleeve according to MIL-STD 130.
CAGE CODE
PART NUMBER
D-16. M1089 30K WINCH TEST ADAPTER
Assemble the M1089 30K winch test adapter according to the following steps. Refer to the following parts list and
Figure D-26. M1089 30K Winch Test Adapter for details.
Part Number
Material Description
National Stock
Number
Qty
4-4-4 100401BA
Tee, Tube
4730-01-095-3430
1
4-6 100102BA
Adapter, Straight, Pipe to Tube
4730-01-096-9398
1
207P-4
Coupling, Pipe
4730-00-881-1161
1
NB-4-035
Tubing, Nonmetallic
4720-01-071-4042
4 in.
MIL-T-27730
Tape, Antiseizing
8030-00-889-3534
1 roll
Figure D-26. M1089 30K Winch Test Adapter
a. All dimensions are in inches (millimeters).
b. Cut two pieces of nonmetallic tubing (1 and 2) to 2.0 in. (50.8 mm) long.
c. Remove three nuts (3), sleeves (4), and ferrules (5) from tube tee (6).
d. Install two nuts (3), sleeves (4), and ferrules (5) on nonmetallic tubing (1).
e. Install nonmetallic tubing (1) on tube tee (6).
f. Remove nut (7), sleeve (8), and ferrule (9) from straight adapter (10).
g. Install two nuts (3 and 7), sleeves (4 and 8), and ferrules (5 and 9) on nonmetallic tubing (2).
h. Install nonmetallic tubing (2) on tube tee (6).
i. Install nut (9) on straight adapter (10).
j. Apply one wrap of antiseizing tape to threads of straight adapter (10).
k. Install pipe coupling (11) on straight adapter (10).
D-32
Change 1
