TM 9-2320-366-34-2
(12) Remove three self-locking nuts (22), bolts (23), cab tilt
cylinder bracket (21), and plate (24) from right frame rail
(25). Discard self-locking nuts.
(13) Remove two bolts (26) and right front spring front
bracket (27) from right frame rail (25).
b. Front Spring Front Bracket Installation.
WARNING
Adhesive sealant MIL-S-46163 can damage
your eyes. Wear safety goggles when
using; avoid contact with eyes. If sealant
contacts eyes, flush eyes with water and
get immediate medical attention. Failure
to comply may result in injury to
personnel.
NOTE
Perform steps (1) through (6) on right side
front spring front bracket.
(1) Apply sealing compound to threads of two bolts (1).
(2) Position right front spring front bracket (2) on right frame
rail (3) with two bolts (1).
(3) Tighten two bolts (1) to 195-240 lb-ft (265-325 N·m).
(4) Position plate (4) and cab tilt cylinder bracket (5) on right
frame rail (3) with three bolts (6) and self-locking nuts
(7).
(5) Tighten three self-locking nuts (7) to 210-225 lb-ft (285-
305 N·m).
14-25
