8-3. TRANSFER CASE MODULE SEAL AND DRIVE YOKE REPLACEMENT (CONT)
(6) Remove drive shaft (7) from frame (8).
Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply
may result in injury to personnel or
damage to equipment.
Check bearing cups to ensure all needle
bearings are in place prior to installation.
Replace bearing cups if needle bearings are
missing or out of place. Failure to comply
may result in damage to equipment.
Wipe end of yoke bearing bores prior to
(7) Position universal joint (9) on drive yoke (3) with two
bearing cups (10) and four screws (11).
Alternately tighten screws.
When correct torque is reached, bearing cap
small screw hex head will break off.
(8) Tighten four screws (11).
Grease must flow from all four seals. Failure
to comply may result in damage to
(9) Apply lubrication to grease fittings (TM 9-2320-366-20).