TM 9-2320-366-34-4
18-2. M1083 PINTLE HOOK EXTENSION KIT INITIAL INSTALLATION (CONT)
(89) Extend rear axle shock absorber (23) length to align with
hole in rear axle shock absorber front bracket (24).
NOTE
Perform steps (90) and (91) on vehicle serial
numbers 1399 through 2987.
(90) Position rear axle shock absorber (23) in rear axle shock
absorber front bracket (24) with three washers (22), bolt
(21), and self-locking nut (20).
(91) Tighten self-locking nut (20) to 196-240 lb-ft (265-325
N·m).
NOTE
Perform steps (92) and (93) on vehicle serial
numbers 0001 through 1398, and 2988 and
higher serial numbers.
(92) Position rear axle shock absorber (23) in rear axle shock
absorber front bracket (24) with washer (22), bolt (21),
and self-locking nut (20).
(93) Tighten self-locking nut (20) to 196-240 lb-ft (265-325
N·m).
(94) Position valve control panel (9) on brackets (10 and 11)
with six washers (8), screws (7), washers (6), and self-
locking nuts (5).
(95) Tighten six screws (7) to 16-21 lb-ft (24-28 N·m).
18-18
Change 1
