TM 9-2320-366-34-4NOTE• Use bolts P/N 12414307-142 on step (47).• Support will be installed with grease fitting facing down.(47) Position support (19) on pintle hook extension (80) withfour bolts (18) and self-locking nuts (17).(48) Position pintle hook extension (80) in vise.(49) Tighten four self-locking nuts (17) to 196-240 lb-ft (265-325 N·m).(50) Position pintle hook (15) in pintle hook extension (80)with washer (14) and nut (13).CAUTIONClearance between washer and support must be0.003-0.017 in. (0.076-0.432 mm). Failure to complymay result in damage to equipment.(51) Adjust nut (13) until clearance is 0.003-0.017 in. (0.076-0.432 mm) with alignment holes lined up between nut(13) and pintle hook (15).(52) Install cotter pin (12) in nut (13).Change 1 18-11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business