TM 9-2320-366-34-4
Section II. MAINTENANCE PROCEDURES
27-2. M1090/M1094 DUMP BODY LIFT CYLINDER REPAIR
This task covers:
a. Disassembly
b. Cleaning/Inspection
c. Assembly
INITIAL SETUP
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque 0-600 lb-ft (Item 97, Appendix B)
Wrench Set, Spanner (TM 9-2320-366-20)
Multiplier, Torque Wrench (Item 42, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Pan, Drain (Item 43, Appendix B)
Gloves, Rubber (Item 26, Appendix B)
Materials/Parts
Kit, Seal (Item 117, Appendix F)
Tape, Antiseizing (Item 85, Appendix C)
Packing, Preformed (Item 288, Appendix F)
Materials/Parts (Cont)
Packing, Preformed (Item 287, Appendix F)
Nut, Self-Locking (Item 196, Appendix F)
Washer, Wave (Item 439, Appendix F)
Spacer, Nylon (Item 421, Appendix F)
Sealing Compound (Item 69, Appendix C)
Solvent, Dry Cleaning (Item 83, Appendix C)
Rag, Wiping (Item 60, Appendix C)
Lubricating Oil, Engine (Item 46, Appendix C)
Personnel Required
(2)
a. Disassembly.
WARNING
Dump
body
lift
cylinder
weighs
approximately 200 lbs (91 kg). Attach a
suitable lifting device prior to lifting.
Failure to comply may result in injury to
personnel or damage to equipment.
(1) Place drain pan under lift cylinder barrel (1).
(2) Extend cylinder rod (2) approximately 12 inches (31 cm).
(3) Loosen screw (3) on collar (4).
(4) Remove collar (4) from lift cylinder barrel (1).
(5) Remove lubrication fitting (5) from lift cylinder barrel (1).
27-2
