TM 9-2320-366-34-4
(18) Position end cap (17) on geroler (15) with seven bolts
(18).
CAUTION
Tighten screws in a crisscross pattern to
properly seat end cap. Failure to comply may
result in damage to equipment.
(19) Tighten bolts (18) to 15-40 lb-in. (2-5 N·m).
(20) Verify geroler (15) and preformed packings (14 and 16)
are properly seated.
(21) Tighten bolts (18) to 20-30 lb-ft (27-41 N·m).
(22) Install preformed packings (19 and 20) on 90-degree
fitting (21).
(23) Install 90-degree fitting (21) in end cap (17).
End of Task.
26-25
