TM 9-2320-366-34-4
(60) Install preformed packing (60) on bearing cage (2).
(61) Apply gear oil to preformed packing (60).
NOTE
End play of the input shaft assembly is adjusted
by thickness of shim pack.
Measure the gap between the input bearing
cage and differential carrier at four equally
spaced points.
Add all four measurements
together and divide by four to determine the
average gap. Add 0.005 in. (0.012 cm) to the
average gap value.
(62) Position bearing cage (2) on differential carrier (14) with
eight screws (61).
(63) Measure gap between bearing cage (2) and differential
carrier (14). Record measurement.
(64) Remove eight screws (61) and bearing cage (2) from
differential carrier (14).
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. Keep
away from open fire and use in a well-
ventilated area.
If adhesive, solvent, or
sealing compound gets on skin or clothing,
wash immediately with soap and water.
Failure to comply may result in injury to
personnel.
(65) Apply adhesive sealant to shim pack (62) and mounting
flange of differential carrier (14).
(66) Position shim pack (62) and bearing cage (2) on
differential carrier (14) with eight washers (63) and
screws (61).
(67) Tighten screws (61) to 74-96 lb-ft (100-130 N·m).
(68) Tighten self-locking nut (8) to 450-601 lb-ft (610-815
Nm).
(69) Tighten self-locking nut (55) to 450-601 lb-ft (610-815
N·m).
(70) Install oil pump (64) on pinion drive shaft (9)
Change 1
24-19
