TM 9-2320-366-34-4
22-4. TRANSFER CASE HOUSING REPAIR (CONT)
(15) Rotate transfer case housing (2) until open end is facing
up.
CAUTION
Ensure center idler, upper drive, and lower
driven gears with bearing cones are seated in
transfer case housing. Failure to comply may
result in damage to equipment.
NOTE
Install idler gear with threaded hole toward
transfer case housing.
(16) Install center idler gear (17) in transfer case housing (2).
(17) Install upper drive gear (19) in transfer case housing (2).
(18) Install lower driven gear (21) in transfer case housing
(2).
WARNING
Transfer case cover weighs approximately 75
lbs (34 kgs). The aid of an assistant is
required to safely lift it. Failure to comply
may result in injury to personnel or damage
to equipment.
NOTE
Step (19) requires the aid of an assistant.
(19) Install gasket (22) and transfer case cover (9) on transfer
case housing (2).
(20) Position 15 bolts (23) in transfer case housing (2).
(21) Tighten 15 bolts (23) to 44-55 lb-ft (60-75 N·m).
(22) Rotate transfer case cover (9) until transfer case housing
(2) is facing up.
22-18
