TM 9-2320-366-34-4
NOTE
Replace any part that fails visual inspection
or size measurement requirements.
(2) Inspect C7 clutch housing (1) for scoring, burring, cracks,
damage to seal ring grooves, and excessive wear.
(3) Inspect front output shaft (2) for scoring, burring, cracks,
deformed splines, and excessive wear.
(4) Inspect two roller bearings (3) for pitting, cage damage,
and excessive wear.
(5) Inspect front output housing (4) for cracks, scoring,
burring, and excessive wear.
(6) Inspect two roller bearing cups (5) for cracks, scoring,
pitting, and excessive wear.
(7) Inspect check ball (6) for damage, excessive wear, and
free movement. Minimum free movement
0.040 in.
(0.101 cm).
(8) Inspect bushing (7) for excessive wear. Maximum inside
diameter 1.861 in. (4.727 cm).
21-73
