TM 9-2320-366-34-3
16-86. PAY-OUT HYDRAULIC MOTOR REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Pan, Drain (Item 43, Appendix B)
Tools and Special Tools (Cont)
Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-
20)
Materials/Parts
Cap and Plug Set (Item 17, Appendix C)
Sealing Compound (Item 75, Appendix C)
Dispenser, Pressure Sensitive Adhesive Tape (Item
30, Appendix C)
Preformed Packing (2) (Item 229, Appendix F)
a. Removal.
CAUTION
Cap or plug hydraulic hoses to prevent
contamination of hydraulic system. Failure to
comply may result in damage to equipment.
NOTE
• Left and right side pay-out hydraulic motors are
removed the same way. Left side shown.
• Tag hydraulic hoses and connection points prior
to disconnecting.
(1) Position drain pan under pay-out hydraulic motor (1).
(2) Disconnect two hoses (2) from fittings (3).
(3) Remove two bolts (4), washers (5), and pay-out
hydraulic motor (1) from spooler weldment (6).
16-535
