TM 9-2320-366-34-3
(65) Remove two quad rings (91) and backup rings (92) from
pinion seal (85). Discard backup rings and quad rings.
(66) Match mark lever cap (88) to bottom directional valve
body (79).
(67) Remove four screws (93), lever cap (88), and preformed
packing (94) from bottom directional valve body (79).
Discard preformed packing.
(68) Match mark end cap (95) to bottom directional valve
body (79).
(69) Remove four screws (96), end cap (95), and preformed
packing (97) from bottom directional valve body (79).
Discard preformed packing.
(70) Remove spool (98) from bottom directional valve body
(79).
(71) Perform steps (56) through (70) on remaining three
bottom directional valve bodies.
NOTE
All solenoid valves are disassembled the
same way. One solenoid valve shown.
(72) Remove nut (99) and coil (100) from solenoid valve
(101).
(73) Remove solenoid valve (101) from valve manifold (25).
(74) Remove preformed packings (102 and 103) and two
backup rings (104) from solenoid valve (101). Discard
preformed packings and backup rings.
(75) Perform steps (72) through (74) on remaining two
solenoid valves.
16-321
