TM 9-2320-366-34-3
16-59. M1089 EIGHT-BANK VALVE ASSEMBLY REPLACEMENT/REPAIR (CONT)
NOTE
All
bottom
directional
valve
bodies
are
disassembled the same way.
One bottom
directional valve body shown.
(56) Remove two fittings (78) from bottom directional valve
body (79).
(57) Remove two preformed packings (80) from fittings (78).
Discard preformed packings.
(58) Remove four screws (81), bottom directional valve body
(79), two preformed packings (82), and three preformed
packings (83) from valve manifold (25).
Discard
preformed packings.
(59) Remove lever (84) from pinion seal (85).
CAUTION
Lever cap and carrier nut are a matched set and
must be kept together. Failure to comply may
result in damage to equipment.
(60) Remove bolt (86) and washer (87) from lever cap (88).
Discard washer.
(61) Remove carrier nut (89) from lever cap (88).
(62) Remove preformed packing (90) from carrier nut (89).
Discard preformed packing.
(63) Match mark pinion seal (85) and lever cap (88).
(64) Remove pinion seal (85) from lever cap (88).
16-320
