TM 9-2320-366-34-3
15-3. CAB FRONT SUPPORT REPLACEMENT/REPAIR (CONT)
NOTE
Steps (64) and (65) require the aid of an
assistant.
(64) Disengage pivot arm (104) and spacer (105) from cab
tilt cylinder mounting bolt (101).
(65) Remove self-locking nut (102), cab tilt cylinder mounting
bolt (101) and cab tilt cylinder (106) from bracket (107).
WARNING
Standard cab weighs approximately 1400
lbs (636 kgs). M1093/M1094 cab weighs
approximately 1700 lbs (772 kgs). Attach
a suitable lifting device prior to removal.
Failure to comply may result in injury to
personnel or damage to equipment.
CAUTION
Use spreader bar and place sheet rubber on
cargo sling to prevent damage to cab roof.
Failure to comply may result in damage to
equipment.
NOTE
Steps (66) through (72) require the aid of two
assistants.
(66) Lower cab door windows and install cargo sling through
rear section of cab doors (108).
15-70
