TM 9-2320-366-34-3
(60) Remove cotter pin (99) and washer (100) from cab tilt
cylinder mounting bolt (101). Discard cotter pin.
(61) Loosen self-locking nut (102) on cab tilt cylinder
mounting bolt (101).
(62) Raise cab slightly and remove cab support tool from
engine rear lifting eye (98) (TM 9-2320-366-10-1).
NOTE
Use wooden block on top of cab hydraulic
latch to prevent cab from latching when cab
is lowered.
(63) Lower cab until cab latch (103) rests on wooden block
(TM 9-2320-366-10-1).
15-69
