TM 9-2320-366-34-2
10-8. REAR AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Puller Kit, Mechanical (Item 51, Appendix B)
Wrench Set, Socket, (Item 84, Appendix B)
Multiplier, Torque Wrench (Item 42, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Hammer, Soft Head (Item 33, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix
B)
Tools and Special Tools (Cont)
Sling, Cargo (Item 56, Appendix B)
Driver, Front and Rear Differential Yoke Seal (Item
54, Appendix D)
Driver, Differential Pinion Seal (Item 51, Appendix D)
Holding Bar, Pinion (TM 9-2320-366-20)
Materials/Parts
Grease, Automotive and Artillery (Item 35, Appendix
C)
Seal, Plain Encase (Item 386.1, Appendix F)
Screw, Cap (4) (Item 366.1, Appendix F)
Nut, Self-Locking (Item 193, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due the possibility
of falling debris. Failure to comply may
result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Push in on propeller shaft (4) to separate universal joint
(5) from drive yoke (3).
NOTE
Step (3) requires the aid of an assistant.
(3) Attach propeller shaft (4) to frame (6).
10-56
Change 1
