TM 9-2320-366-34-2
Section II. MAINTENANCE PROCEDURES
7-2. TORQUE CONVERTER REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d. Assembly
e. Installation
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Transmission mounted on maintenance stand (para 7-5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft. (Item 92, Appendix B)
Gage, Profile (TM 9-2320-366-20)
Caliper, Vernier (Item 11, Appendix B)
Caliper Set, Micrometer Inside (Item 10, Appendix B)
Straight Edge (Item 71, Appendix B)
Gage Set, Telescoping (Item 24, Appendix B)
Gage, Depth, Micrometer (Item 25, Appendix B)
Pan, Drain (Item 43, Appendix B)
Inserter, Bearing and Bushing (TM 9-2320-366-20)
Socket Wrench Attachment, Screwdriver (Item 61,
Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Gloves, Rubber (Item 26, Appendix B)
Chain, Welded (TM 9-2320-366-10)
Adapter (3/8 to 1/2") (NSN 5120-01-335-0701)
Tools and Special Tools (Cont)
Socket Wrench Attachment, Screwdriver (3/4
hex, 1/2 drive) (NSN 5120-01-357-3468)
Materials/Parts
Packing, Retainer (Item 304, Appendix F)
Washer, Seal (Item 435, Appendix F)
Sealring (Item 411, Appendix F)
Spring, Flat (13) (Item 427, Appendix F)
Packing, Retainer (Item 303, Appendix F)
Bolt, Machine (2) (Item 14, Appendix C)
Washer, Flat (2) (Item 95, Appendix C)
Rag, Wiping (Item 60, Appendix C)
Solvent, Dry Cleaning (Item 83, Appendix C)
Personnel Required
(2)
a. Removal.
(1) Rotate transmission on maintenance stand so that torque
converter module (1) is in up position.
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
NOTE
Perform steps (2) through (6) on transmission
serial numbers prior to 6510165560.
(2) Remove retaining ring (2) from torque converter module
(1).
7-2
Change 1
