TM 9-2320-366-34-2CAUTIONEnsure dial indicator lever is in contact withend face of rack bar. Failure to comply mayresult in faulty reading.(6) Firmly push rack head (6) of fuel injector (7) toward fuelinjector until rack stop (8) contacts fuel injector base (9).NOTENo. 1 fuel injector is now in fuel shutoffposition.(7) Hold rack head (6) in shutoff position and adjust dialindicator group until all dials read zero.(8) Tighten dial indicator group and release rack head (6).(9) Remove clip (10) from adapter sleeve (11) between fuelgovernor (12) and inlet manifold (13).(10) Slide sleeve (11) from fuel governor (12) toward cylinderhead (3).(11) Install insertion tool into link pin (14) of output shaft (15).NOTEWhen properly installed, equal lengths of smalldiameter of insertion tool will extend from bothends of link pin.(12) Install holding tool between adapter sleeve (11) andsmall diameter of insertion tool.(13) Push holding tool down until small diameter of insertiontool contacts face of fuel governor (12). This is fuelsetting measurement position.4-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
