TM 9-2320-366-34-2
Figure D-56. Lanyard Assembly
a. All dimensions are in inches (millimeters).
b. Make from bulk cable and flat steel material as identified in parts list.
c. Drill two 0.19 in. (4.8 mm) diameter holes through tab material as shown in Figure D-56 Lanyard Assembly.
d. De-burr and remove sharp edges.
e. Bend tab as shown in Figure D-56 Lanyard Assembly.
f. Form loops on cable ends and insert sleeve material over cable on one end of cable and over cable and through
sleeve at other end of cable as shown in Figure D-56. Lanyard Assembly.
g. Crimp two sleeves over cable ends.
D-70
