Change 1 2-133
TM 9-2320-366-34-1
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector P119-d.
(3) Connect negative (-) probe of multimeter
to external wiring harness 31-pin
connector pin P and note reading on
multimeter.
(4) If continuity is not present, replace
transmission external wiring harness
(para 6-7).
(5) Connect positive (+) probe of multimeter
to connector P119-d.
(6) Connect negative (-) probe of multimeter
to all other pins in connector P119 and
note reading on multimeter.
(7) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8) If continuity is present, transmission
external cable assembly is shorted;
replace transmission external wiring
harness (para 6-7).
(9) Connect connector P119 to connector
J119.
(10) Position front grille on cab with washer
and screw.
CONTINUITY TEST
(11) Position two washers and screws in front
grille.
(12) Tighten screw to 48-60 lb-in. (5-7 N·m).
(13) Tighten two screws to 24 lb-in. (3 N·m).
