TM 9-2320-366-34-2
(3) Stow two clamps (4), hose (5), turbocharger inlet
coupling (2), and clamp (1) in engine container base (6).
(4) Install plastic wrapper (7) on engine speed sensor
connector (8) with duct tape.
(5) Install plastic wrapper (9) on fuel/water separator bowl
heater connector (10) with duct tape.
(6) Install dust cap (11) on 90-degree fitting (12).
(7) Install plastic wrapper (13) on oil pressure light switch
connector (14) with duct tape.
(8) Install dust cap (15) on air compressor (16).
(9) Install dust cap (17) on 90-degree fitting (18).
(10) Install dust cap (19) on power steering pump supply tube
(20) with clamp (21).
3-9