7-4. TRANSMISSION ASSEMBLY REPLACEMENT (USUAL CONDITIONS) (CONT)
Perform steps (22) and (23) if pressure
plate assembly was removed from
transmission serial numbers prior to
(22) Position pressure plate assembly (24) on transmission
(1) with 20 bolts (25).
(23) Tighten 20 bolts (25) to 18-22 lb-ft (24-30 N·m).
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing compound
gets on skin or clothing, wash immediately
with soap and water. Failure to comply
may result in injury to personnel.
Apply light coat of sealing compound to seating
surface (26) on transmission (1).
(25) Install gasket (27) on transmission (1).
Perform step (28) on vehicles equipped
with transmission oil cooler tubes.
(26) Connect transmission oil cooler hose (28) to fitting