• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369        WITH TRANSMISSION ADAPTER CABLE ASSEMBLY) (CONT)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369        WITH TRANSMISSION ADAPTER CABLE ASSEMBLY) (CONT)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  529    530    531    532    533  534  535    536    537    538    539  
TM 9-2320-366-34-1 Change 1          2-475 CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST   (1)  Remove control valve module (para 7-10).   (2)  Remove four screws and cover from         control valve module.   (3)  Disconnect internal wiring harness         connector N from N solenoid connector.   (4)  Set multimeter to ohms.   (5)  Connect positive (+) probe of multimeter         to internal wiring harness 24-pin connector         pin H3.   (6)  Connect negative (-) probe of multimeter to         internal wiring harness connector N pin A         and note reading on multimeter.   (7)  If continuity is not present, replace         transmission internal wiring harness         (para 7-13).   (8)  Connect positive (+) probe of multimeter         to internal wiring harness 24-pin connector         pin H3.   (9)  Connect negative (-) probe of multimeter to         all other pins in internal wiring harness         24-pin connector and note reading on         multimeter. (10)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter. (11)  If continuity is present, transmission         internal wiring harness is shorted; replace         transmission internal wiring harness         (para 7-13).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.