• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, 45 AND/OR 69 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369        WITH TRANSMISSION ADAPTER CABLE ASSEMBLY) (CONT)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, 45, AND/OR 69 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  533    534    535    536    537  538  539    540    541    542    543  
TM 9-2320-366-34-1 Change 1          2-479 CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. RESISTANCE TEST (1)  Set multimeter to ohms. (2)  Connect positive (+) probe of multimeter       to N solenoid connector pin A. (3)  Connect negative (-) probe of multimeter       to N solenoid connector pin B and note       reading on multimeter. (4)  If resistance is less than 2.5 ohms or       greater than 5.0 ohms, replace N solenoid       (para 7-7). (5)  If resistance is between 2.5-5.0 ohms,       replace WTEC II TEPSS (TM 9-2320-366-       20-4). (6)  Connect internal wiring harness connector N       to N solenoid connector. (7)  Install cover on control valve module with       four screws. (8)  Install control valve module (para 7-10). (9)  Connect batteries (TM 9-2320-366-20-3).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.