• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS           MAIN CODE 41, 42, 44, AND/OR 45 SUB CODE 24 (SERIAL NUMBER 6510032369           AND HIGHER) (CONT)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 24 (PRIOR TO SERIAL NUMBER 6510032369        WITH TRANSMISSION ADAPTER CABLE ASSEMBLY)

TM-9-2320-366-34-1 M1078 Series 2 1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  485    486    487    488    489  490  491    492    493    494    495  
TM 9-2320-366-34-1 Change 1          2-431 RESISTANCE TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter         to J solenoid connector pin A.   (3)  Connect negative (-) probe of multimeter         to J solenoid connector pin B and note         reading on multimeter.   (4)  If resistance is less than 2.5 ohms or         greater than 5.0 ohms, replace         J solenoid (para 7-7).   (5)  If resistance is between 2.5-5.0 ohms,         replace WTEC II TEPSS (TM 9-2320-366-         20-4).   (6)  Connect internal wiring harness         connector J to J solenoid connector.   (7)  Install cover on control valve module with         four screws.   (8)  Install control valve module (para 7-10).   (9)  Connect batteries (TM 9-2320-366-20-3).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.