TM 9-2320-366-34-1 Change 1          2-427 CONTINUITY TEST NOTE CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Remove control valve module (para 7-10).   (2)  Remove four screws and cover from         control valve module.   (3)  Disconnect internal wiring harness         connector J from J solenoid connector.   (4)  Set multimeter to ohms.   (5)  Connect positive (+) probe of multimeter         to internal wiring harness 31-pin connector         pin g.   (6)  Connect negative (-) probe of multimeter to         internal wiring harness connector J pin A         and note reading on multimeter.   (7)  If continuity is not present, replace         transmission internal wiring harness         (para 7-13).   (8)  Connect positive (+) probe of multimeter         to internal wiring harness 31-pin connector         pin g.   (9)  Connect negative (-) probe of multimeter to         all other pins in internal wiring harness         31-pin connector and note reading on         multimeter. (10)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter. (11)  If continuity is present, transmission         internal wiring harness is shorted; replace         transmission internal wiring harness         (para 7-13).