TM 9-2320-366-34-4
(5) Apply sealing compound to injector sleeve bore (1) in
cylinder head (2) and outside of injector sleeve (3) at
locations (A and B).
(6) Install injector sleeve (3) in injector sleeve bore (1) in
cylinder head (2).
Wipe away any excess sealing
compound that is either in or above injector sleeve.
(7) Apply grease to lubricate swage assembly (4) and upper
inside injector sleeve bore (1).
(8) Install swage assembly (4) in injector sleeve (3). Push
injector sleeve all the way to the bottom of injector
sleeve bore (1) in cylinder head (2).
NOTE
Use large bushing (identified by an "L" or by
a coarse knurl) if it will slip into bore with
hand force.
If large bushing can not be
installed as stated, select smaller bushing
(identified by an "S" or a fine knurl).
(9) Install guide bushing (5) over swage assembly (4) and
into injector sleeve bore (1).
(10) Position driver (6) over swage assembly (4).
20-19
