TM 9-2320-366-34-4
NOTE
Approximate depth of thread engagement is
0.375 in. (0.9525 cm). If puller assembly will
not engage to this depth, continue to cut
threads until this depth is achieved.
(27) Apply sealing compound on threaded stem of puller
assembly (16).
(28) Install puller assembly (16) into injector sleeve (11).
(29) Install reaction sleeve (17) and plate (18) over threaded
stem of puller assembly (16).
(30) Position thrust bearing (19) on plate (18).
(31) Position washer (20) on thrust bearing (19).
(32) Install nut (21) on threaded stem of puller assembly (16).
CAUTION
Stop pulling on injector sleeve when it pulls free
from lower bore. Manually lift puller assembly
enough to center injector sleeve in upper bore
before using wrench to pull injector sleeve
through upper bore. Failure to center injector
sleeve in upper bore may result in damage to
cylinder head or tool.
NOTE
Upper bore in cylinder head is small enough that
injector sleeve must be pulled through that bore
also.
(33) Remove injector sleeve (11) from cylinder head (1).
(34) Remove nut (21), washer (20), thrust bearing (19), plate
(18), and reaction sleeve (17) from puller assembly (16).
(35) Remove injector sleeve (11) from puller assembly (16).
20-9
