TM 9-2320-366-34-3
15-2. CAB REPLACEMENT (CONT)
INITIAL SETUP (CONT)
Materials/Parts (Cont)
Antifreeze (Item 11, Appendix C)
Sealing Compound (Item 70, Appendix C)
Rubber, Sheet (Item 64, Appendix C)
Nut, Self-locking (Item 214, Appendix F)
Lockwasher (Item 128, Appendix F)
Washer, Spring Tension (Item 437, Appendix F)
Seal, Door (2) (Item 373, Appendix F)
Nut, Clinch (61) (Item 169, Appendix F)
Nut, Clinch (4) (Item 170, Appendix F)
Pin, Cotter (Item 330, Appendix F)
Seal (Item 366, Appendix F)
Plug, Plastic (2) (Item 344, Appendix F)
Rivet, Compression (5) (Item 365, Appendix F)
Sealing Compound (Item 76.1, Appendix C)
Materials/Parts (Cont)
Plug, Plastic (10) (Item 345, Appendix F)
Plug, Rubber (6) (Item 348, Appendix F)
Plug, Rubber (6) (Item 351, Appendix F)
Plug, Rubber (6) (Item 347, Appendix F)
Plug, Rubber (2) (Item 346, Appendix F)
Plug, Rubber (4) (Item 350, Appendix F)
Plug, Rubber (13) (Item 349, Appendix F)
Plug, Rubber (2) (Item 350, Appendix F)
Lockwasher (4) (Item 132, Appendix F)
Adhesive (Item 10, Appendix C)
Rubber Strip (Item 366, Appendix F)
Adhesive (item 10, Appendix C)
Nut, Self-Locking (4) (Item 214, Appendix F)
Personnel Required
(2)
a. Removal.
NOTE
Remove plastic cable ties as required.
(1) Remove vacuum hose (1) from dashboard (2).
(2) Remove engine control cable assembly (3) and start and
charging cable assembly (4) from dashboard (2).
(3) Disconnect connector P119 (5) from connector J119 (6).
NOTE
Steps (4) and (5) require the aid of an
assistant.
(4) Remove vacuum hose (1) from cab (7).
(5) Remove engine control cable assembly (3), start and
charging cable assembly (4), and grommet (8) from cab
(7).
Change 1
15-3
