TM 9-2320-366-34-3
16-55. M1089 HYDRAULIC ORBIT MOTOR REPLACEMENT (CONT)
(2) Remove two screws (3), washers (4), and hydraulic orbit
motor (5) from swing drive assembly (6).
(3) Remove 90-degree fitting (2) from hydraulic orbit motor
(5).
(4) Remove preformed packings (7 and 8) from 90-degree
fitting (2). Discard preformed packings.
b. Installation.
(1) Install preformed packings (1 and 2) on 90-degree fitting
(3).
(2) Install 90-degree fitting (3) in hydraulic orbit motor (4).
WARNING
Adhesive sealant MIL-S-46163 can damage
your eyes. Wear safety goggles/glasses
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(3) Apply sealing compound to threads of two screws (5).
(4) Position hydraulic orbit motor (4) on swing drive
assembly (6) with two washers (7) and screws (5).
(5) Tighten screws (5) to 40 lb-ft (54 N·m).
16-300